The Lupolux 800 HMI spotlight takes about three minutes to reach peak brightness and correct colour temperature, just like a data projector. During this warm up phase the colour of the light will vary slightly. Once lit, the light will continue to burn for as long as you need. Once switched off, the 800 will not ‘re-strike’ for about four or five minutes until the bulb is once again cool. The lamp life is over 12,000 hours and the lights are extremely resilient, so you need not fear about the bulb blowing if switched on while still hot. Unlike other continuous lamps, the outer shell will get no hotter than an average household radiator and the light created will stay as cool as your subject.
- Beautiful cool light rendering
- Ideal for Hollywood lighting
- Flood and spot control
- Simple to use
- All the benefits of continuous lighting
- Super lightweight construction
- Small and compact
- Vastly more affordable than other HMI lighting
- Technical email support for all customers
- Quiet running ideal for videographers
The Fresnel Spot Daylight 800 (5600°K)
The Lupolux 800 has a power consumption of 150w and has a light output roughly equivalent to an 800w tungsten light fitted with full CTB gel, hence the 800 in it’s name.
The ‘800’ is the photographers subtle light of choice to be used where an Arri 300w might have been chosen. It has a super wide even light pattern in full flood mode and can zoom into a football sized spot of light at 3m distance. It is silent in operation and perfect for movie making too. You can gel this lamp with a full CTO (colour temperature orange) gel to match a tungsten lit interior and still get the same light output as the Arri 300w unit. The bulbs last a great deal longer too, so in the long term the running cost of this light will be lower than the Arri.
Comparing Technical Specification
Lupolux lights come with a choice of plug types. Choose between USA 3 pin (plug type B), European 2 pin plus earth (plug type F), or UK 3 pin (plug type G). Read this chart for identification. http://www.worldstandards.eu/electricity/plugs-and-sockets/
All Lupolux HMI lights come supplied with a bulb. To ensure the safe delivery of bulbs they will not be fitted inside the lamp but wrapped up separately. They are very easy to fit however by simply unscrewing the front casing and inserting the bulb.
Buying replacement bulbs
Some earlier Lupolux HMI 1200 models may require a Sylvania bulb rather than the Phillips bulbs. The bulb you require will be the same brand as that already fitted. So to check your current lamp/bulb brand, undo the screws near the hinge of the lens. If it’s a Sylvania lamp please email us for a quote, if it’s Philips or Osram take a look here for options.
Shipping to the UK will be via an insured signed-for courier service. Occasionally we need to ship the lamps directly from Italy so delivery can take up to 7 days.
IMPORTANT NOTE: International Shipping
Shipping fees to locations outside of the UK are very high for this item. The cost can fluctuate daily, so we therefore ask if you could please contact us first for a quote as you may not be charged enough by placing your order online.
A note about stock
Please note: Warm 3200°K lights are available but we don’t hold regular stock of them and a shipping charge will be applicable. Delivery from 7-10 days.
All Lupolux lamps come with a one year warranty.
Using the HMI 800 in the USA
The Lupolux 800 will require a step down power converter from 220V to 110V to work in North America. They are quite cheap and easy to find in most electronics store. Alternatively you can choose the DayLED 650 or DayLED 1000 which are auto sensing units that can work anywhere within a 90-240V range.